-Homoepitaxial growth of 3C-SiC by GSMBE was realized for the first time by atomic layer epitaxy (ALE) utilizing the change in the surface superstructure, which gives atomic level control in the growth process \cite{fuyuki89}.
-in more detail ... \cite{yoshinobu90}.
-3C on 3C homoepitaxy by ALE \cite{fuyuki89,fuyuki93,hara93}
-6H on 6H ... \cite{tanaka94}
-Problem of gas source ... strong adsorption and incorporation of atomic decomposited hydrogen of the gas phase reactants at low temperatures.
-Growth rate lower than desorption rate of hydrogen ...
-Solid source MBE may be the key to avoid such problems ...
+Homoepitaxial growth of 3C-SiC by GSMBE was realized for the first time by atomic layer epitaxy (ALE) utilizing the periodical change in the surface superstructure by the alternating supply of the source gases, which determines the growth rate giving atomic level control in the growth process \cite{fuyuki89}.
+The cleaned substrate surface shows a C terminated $(2\times 2)$ pattern at \unit[1000]{$^{\circ}$C}, which turns into a $(3\times 2)$ pattern when Si$_2$H$_6$ is introduced and it is maintained after the supply is stopped.
+A more detailed investigation showed the formation of a preceeding $(2\times 1)$ and $(5\times 2)$ pattern within the exposure to the Si containing gas \cite{yoshinobu90,fuyuki93}.
+The $(3\times 2)$ superstructure contains approximately 1.7 monolayers of Si atoms, crystallizing into 3C-SiC with a smooth and mirror-like surface after C$_2$H$_6$ is inserted accompanied by a reconstruction of the surface into the initial C terminated $(2\times 2)$ pattern.
+A minimal growth rate of 2.3 monolayers per cycle exceeding the value of 1.7 is due to physically adsorbed Si atoms not contributing to the superstructure.
+To realize single monolayer growth precise control of the gas supply to form the $(2\times 1)$ structure is required.
+However, accurate layer-by-layer growth is achieved under certain conditions, which facilitate the spontaneous desorption of an additional layer of one atom species by supply of the other species \cite{hara93}.
+Homoepitaxial growth of the 6H polytype has been realized on off-oriented substrates utilizing simultaneous supply of the source gases \cite{tanaka94}.
+Depending on the gas flow ratio either 3C island formation or step flow growth of the 6H polytype occurs, which is explained by a model including aspects of enhanced surface mobilities of adatoms on a $(3\times 3)$ reconstructed surface.
+Due to the strong adsorption of atomic hydrogen \cite{allendorf91} decomposited of the gas phase reactants at low temperatures, however, there seems to be no benefit of GSMBE compared to CVD.
+Next to lattice imperfections, incorporated hydrogen effects the surface mobility of the adsorbed species \cite{eaglesham93} setting a minimum limit for the growth temperature, which would preferably be further decreased in order to obtain sharp doping profiles.
+Thus, growth rates must be adjusted to be lower than the desorption rate of hydrogen, which leads to very low deposition rates at low temperatures.
+Solid source MBE (SSMBE) may constitute the preffered method to avoid these problems.